Mitel 6800 Series SIP Phone Release 4.2.0 Administrator Guide
ACD SUBSCRIPTION PERIOD
On the IP phones, you can set the time period, in seconds, that the IP phone resubscribes the
ACD subscription service after a software/firmware upgrade or after a reboot of the IP phone.
In the configuration files, you enter the following parameter with a valid value to set the ACD
subscription period:
sip acd subscription period: <value in seconds>
The minimum value for this 120 seconds (2 minutes).
The default is 3600 (1 hour).
Setting this parameter to a value lower than 3600 allows the configured ACD feature to become
active more quickly after a software/firmware upgrade or after a reboot of the IP phone. If you
enter a value lower than 120 for this parameter, the default value (3600) will be used by the IP
phone.
You can configure this feature using the configuration files or the Mitel Web UI.
CONFIGURING ACD SUBSCRIPTION PERIOD
Use the following procedures to configure the ACD subscription period on the IP phone.
CONFIGURATION FILES
To configure the ACD subscription period on the IP phones using the configuration files, see
Appendix A, the section,
5-191
on
"Advanced SIP Settings"
.
page A-95