Mitel 6800 Series SIP Phone Release 4.2.0 Administrator Guide
FORMAT
DEFAULT VALUE
RANGE
EXAMPLE
The following table identifies the language code to use for the IP phone language packs.
A-194
You can use this parameter in three ways:
• To download no language packs
• To download a language pack(s) from the original configuration
server
• To download a language pack(s) from another specified server
Notes:
• The languages packs you load are dependent on available
language packs from the configuration server. For more
information about loading language packs, see
Language Packs"
on
page
• You must reboot the phone to load a language pack.
• To download a specific file, the string value MUST HAVE A
FILENAME at the end of the string. For example:
language 1:ftp://admin:admin!@1.2.3.4:50/path/lang_de.txt
where "path" is the directory and "lang_de.txt" is the filename. If
you do not specify a filename, the download fails.
See examples for each below.
lang_<ISO 639>_<ISO 3166>.txt
or
lang_<ISO 639>.txt
Note: For valid values for <ISO 639> and <ISO 3166>, see
"Language Codes (from Standard ISO 639)"
"Country Codes (from Standard ISO 3166)"
N/A
N/A
The following example downloads no language pack file:
• language 1:
The following example downloads the German language pack to the
phones from the original configuration server:
• language 1: lang_de.txt
The following example uses FTP to download the firmware file
"lang_de.txt" (German language pack) from the "path" directory on
server 1.2.3.4 using port 50:
• language 1:ftp://admin:admin!@1.2.3.4:50/path/lang_de.txt
"Loading
5-51.
on
page A-195
on
page
A-196.
and