Mitel 6800 Series SIP Phone Release 4.2.0 Administrator Guide
2. Or, for per-line configuration, click on Advanced Settings->Line N ->Basic SIP Authen-
tication Settings.
Configure SIP Authentication Settings:
3. In the "Screen Name" field, enter the screen name that displays on the idle screen.
4. In the "Screen Name 2" field, enter the text you want to display on the phone under the
"Screen Name" on the idle screen.
Notes:
1. If other status messages display on the phone, such as "Network Disconnected",
2. Symbol characters are allowed (such as "#").
3. If the text is longer than the display width, than the display truncates the text to
5. In the "Phone Number" field, enter the phone number of the IP phone.
6. In the "Caller ID" field, enter the phone number of the IP phone.
7. In the "Authentication Name" field, enter the name used in the username field of the
Authorization header of the SIP REGISTER request.
8. In the "Password" field, enter the password used to register the IP phone with the SIP proxy.
Note: The IP phones accept numeric passwords only.
9. In the "BLA Number" field, enter the Bridge Line Appearance (BLA) number to be shared
across all IP phones.
For more information about setting the BLA on the phone, see Chapter 5, the section,
"Bridged Line Appearance (BLA)"
10. In the "Line Mode" field, select "Generic" for normal mode, "BroadSoft SCA" for a Broad-
Works network.
Configure Global Call Waiting:
11. The "Call Waiting" field is enabled by default. To disable call waiting on a global basis,
uncheck this box.
4-71
the Screen Name 2 value does not display.
fit the display.
on
.
page 5-201