Mitel 6867i Administrator's Manual page 436

Mitel 6800 Series SIP Phone Release 4.2.0 Administrator Guide
The following table details the ring splash behavior in the different call states/events when the
feature is enabled for active calls states. The behavior is consistent for all audio sources and
audio mode configurations.
STATE
Idle
Active Call
Call Waiting
Mid-Conference/Transfer Establishment
Do Not Disturb (Idle/In Call)
Hold
Ringing - Outgoing
Ringing - Incoming
Initiating a direct call pickup of the BLF target
Initiating a speeddial of the BLF target
CONSIDERATIONS
The following considerations must be taken into account when using this feature:
• When a BLF or BLF/List softkey's ring splash parameter is dynamically changed, the change
will not take effect until the BLF target becomes idle.
• The playing of a ring splash will be postponed if it is not allowed to be played in the current
state and will start playing if the phone transitions to a state where the ring splash can be
played. However, if the BLF target stops ringing before the transition, the ring splash will
not be played.
• The playing of a delayed ring splash will be postponed until the delay expires. However, if
the BLF target stops ringing before the delay expires, the ring splash will not be played.
• In scenarios where the BLF target goes into the ringing state while an initial in-call ring
splash is playing or while a call hold or call waiting reminder is playing, the secondary in-call
ring splash will be played 500ms after the current event has ended. The inverse is also true
whereby call hold or call waiting reminders will be played 500ms after the BLF ring splash,
if they occur while a BLF ring splash is playing.
• In scenarios where multiple keys are configured for periodic ring splashes and multiple BLF
targets are ringing, only one periodic ring splash for one target will be played.
• While on an active call, if the "ring audibly enable" parameter is enabled and a call is
incoming while a periodic ring splash is playing, the periodic ring splash will stop allowing
the incoming call's ring tone to be played, and then resume after the incoming call's ring
tone has ended.
5-175
BEHAVIOR
Ring splash played through the speaker.
Ring splash played through the speaker.
Ring splash played through speaker.
Ring splash played through speaker.
No ring splash played.
Ring splash played through speaker.
Ring splash played through speaker.
No ring splash played.
No ring splash played.
No ring splash played.