Switch Focus To Ringing Line - Mitel 6867i Administrator's Manual

Mitel 6800 Series SIP Phone Release 4.2.0 Administrator Guide
2. In the "Status Scroll Delay (seconds)" field, enter a value, in seconds, that each XML
status message displays on the phone. Default is 5 seconds. Valid values are 1 to 25.
3. Click Save Settings to save your changes.

SWITCH FOCUS TO RINGING LINE

An Administrator or User can control the behavior of the phone when it receives an incoming
call when it is already in a connected call. By default, the phone switches focus to the ringing
line to enable the user to see who is calling them.
You can turn off this functionality so that the phone now stays focused on the connected call.
You can do this using the "switch focus to ringing line" parameter in the configuration files
or the Mitel Web UI.
Note: If you configure the BLF/Xfer key(s) and/or Speeddial/Xfer key(s) on the phone,
you can enable or disable the switching of the user interface focus to ringing line while
the phone is in the connected state.
CONFIGURING "SWITCH FOCUS TO RINGING LINE"
You use the following procedures to enable or disable "Switch Focus to Ringing Line".
CONFIGURATION FILES
For specific parameters you can set in the configuration files for enabling disabling "Switch
Focus to Ringing Line", see Appendix A, the section,
5-83
"Switch Focus to Ringing Line"
on .
page A-176