Configuration Example - Mitel 6867i Administrator's Manual

Mitel 6800 Series SIP Phone Release 4.2.0 Administrator Guide
You must associate the softkeyN state parameter with a specific softkey. In the following
example, the softkeyN states parameter is associated with softkey 12:
softkey12 type: speeddial
softkey12 label: voicemail
softkey12 value *89
softkey12 states: outgoing
Notes:
1. By default the IP phone idle screen collapses the softkeys. So in the previous
example, softkey 12 will appear in position 1 if no other softkeys are set.
2. A softkey type of "empty" does not display on the idle screen at all. For more
information about the softkey type of "empty" see Appendix A, the section,
Settings"

CONFIGURATION EXAMPLE

The following example illustrates the use of the "softkeyN states" parameter, and the "softkeyN
type" parameter with a value of empty. For clarity purposes, only the "softkeyN type" and
"softkeyN states" parameters are shown.
softkey1 type: callers
softkey1 states: idle connected
softkey3 type: dnd
softkey3 states: idle
softkey4 type: redial
softkey5 type: empty
softkey5 states: connected
softkey6 type: speeddial
softkey6 states: connected
The following table shows how the keys in the example above would display on the IP Phone UI.
Note: The "empty" key type allows a softkey to be removed quickly by deleting the
softkey information from the configuration file.
SOFTKEY
softkey1
softkey2
softkey3
softkey4
5-141
on page 218.
IDLE CONNECTED
Key 1 Key 2
(not used) (not used)
Key 2 (not used)
Key 3 Key 3
NOTES
Received Callers List displays for softkey1.
Key 1 in connected state is the Drop key. Idle
and connected display as applicable.
Softkey2 is not displayed.
DND displays for softkey3. Idle displays as
applicable.
Redial displays for softkey4. Default state
values (idle, connected, incoming, outgoing,
busy) display as applicable.
"Softkey