Brocade Communications Systems WFT-2D User Manual page 312

6
Reports
TABLE 24
Host Adapter Inventory Report fields and components (Continued)
Field/Component
Switch IP Address
Fabric Assigned Address
WWN Source
Boot Over SAN
Max Supported Speed
Status
Host Adapter with Unsupported and Faulty SFP reports
The Adapters Faulty SFP report lists all Brocade adapters with unsupported or faulty small
form-factor pluggable (SFP) transceivers. This report is only available for Brocade adapters.
For adapters with unsupported SFPs, this report is the same as the Adapters Inventory report
filtered to show only those hosts with adapter ports that have unsupported SFPs. For a complete
list of fields and components of the Adapters Inventory report, refer to the
reports"
For adapters with degrading SFPs, there are additional columns in the table that show the
SFP/SFP+ and pluggable optical module (POM) properties for the degrading SFP.
Table 25
content and table functions, refer to
TABLE 25
Field/Component
SFP Supported
Connector Type
Transceiver
Media
Speed
Extended ID
Encoding
Baud Rate
Length 9U1
Length 9U2
Length 50u
Length 62.5u
260
Description
The IP address for the connected switch.
The state (enabled or disabled) of the fabric-assigned address for the adapter.
The source of the world wide name. Options include:
•
Fabric — The WWN is assigned from the fabric. The fabric assigned address must be
enabled.
•
Factory — The WWN is assigned at the factory.
Indicates whether boot over SAN is enabled.
The maximum speed that is supported on the port. For the FC port, the maximum speed is 8
Gbps.
The adapter status; for example, enabled.
on page 259.
describes the SFP and POM fields of the Adapters Faulty SFP Report. For general report
Adapters Faulty SFP report fields and components
Description
Whether the SFP is supported or not.
The type of port connector; for example, LC. SC, or Cu (copper cable).
The type of transceiver; for example, SFP or SFP+.
The type of media for the transceiver; for example, single mode.
The port speed.
The identifier for the extended link.
Displays how the extended link is encoded, for example, 8B10B.
The transmission rate, roughly equivalent to the number of bits per second.
The length of the single-mode fiber-optic cable, used in situations where gigabit
performance is not required (for distances greater than 100 meters).
The length of the single-mode fiber-optic cable, used in situations where gigabit
performance is not required (for distances greater than 100 meters).
The length of the 50u fiber-optic cable (for distances greater than 10 meters).
The length of the 62.5u fiber-optic cable (for distances greater than 10 meters).
"Report content and functions"
Brocade Network Advisor SAN User Manual
"Host Adapter Inventory
on page 261.
53-1003154-01