Span Configuration Commands; Monitor Session - D-Link DES-7200 Cli Reference Manual

DES-7200 CLI Reference Guide
19

19.1 monitor session

Use this command to create a SPAN session and specify the destination port (monitoring
port) and source port (monitored port). The no form of the command is used to delete the
session or delete the source port or destination port separately.
monitor session session_number {source interface interface-id [both | rx | tx] |
destination interface interface-id [ switch ]} [acl name]
no monitor session session_number [source interface interface-id [both | rx | tx] |
destination interface interface-id [ switch ]} [acl name]
no monitor session all
Parameter
description
Command
mode
SPAN Configuration
Commands
Parameter Description
session_number
SPAN session number
Specify the source port.
source interface
interface-id: interface ID, which can be physical
interface-id
interface, not SVI. DES-7200 supports AP.
destination Specify the destination port.
interface interface-id: interface ID, which can be physical
interface-id interface, not SVI. DES-7200 supports AP.
Monitor the inbounding and outbounding frames
both acl name simultaneously.
acl name/id of monitored flow
Monitor only the inbounding frames.
rx
tx Monitor only the outbounding frames.
all Delete all sessions.
Enable switching on the mirroring destination
switch
port. It is disabled by default.
Global configuration mode.
Chapter 19 SPAN Configuration Commands
19-1