Difficulty Logging In As Mlusr - Nortel Meridian Meridian 1 Maintenance Manual

Difficulty logging in as mlusr

You can login to mlusr at the ÒConsole login:Ó prompt or by using the
mlusr command from maint.
If the login is successful and the Òmlusr>Ó prompt appears, the system is
ready to accept additional commands.
¥ If logging in as mlusr results in the following message
ÒapplicationÓ software not responding.
Administration tool unable to register.
Is ÒapplicationÓ software installed and running?
Login as maint, and execute mlstart.
Goodbye...
in which ÒapplicationÓ represents the name of the application, power
down the Application Module and reboot.
¥ If logging in as mlusr results in a ÒLogin incorrectÓ message, verify
that the password is correct. The default password for mlusr is mlusr.
Also make sure that, if the password is in lowercase, CAPS LOCK is
not set.
¥ If you are able to enter the login ID and password successfully but do
not get the Òmlusr>Ó prompt, or if you are unable to enter input at the
prompt, verify that the console setup is correct. Refer to the Meridian
Link/Customer Controlled Routing Installation and Upgrade Guide
(NTP 553-3202-210).
¥ If logging into mlusr is still unsuccessful, restart the Application
Module by logging into maint and using the powerdown command.
When the ÒSystem secured for powering downÓ message appears,
press the red
Application Module SBC card.
After the Application Module has rebooted, start the application.
¥ If you still cannot log in as mlusr, reinstall the application software as
described in Chapter 8, ÒRecovery/replacement procedures.Ó
Meridian Link Release 5C/CCR Release 3C Diagnostic and Maintenance Guide
button on the IPE Module faceplate or
RESET
Chapter 4: Diagnosing faults 209