Nortel Meridian Meridian 1 Maintenance Manual page 409

Procedure 19: Load the operating system tape on an Application
Module with an MVME147 card (continued)
8 The LUN results appear (Figure 43). Type y and press [Return] to
save the map in non-volatile memory.
9 The Ò147-Diag>Ó prompt reappears. Type ab and press [Return] to
set autoboot enable.
Autoboot enable prompts appear. Answer them as indicated below.
Figure 44
Autoboot enable prompts
Controller LUN = 00?
Device LUN = 00?
Default String =
Boot at Power-up only or any board Reset [P,R] = R?
On any board Reset:
Auto Boot from Controller 0, Device 0
10 At the Ò147-Diag>Ó prompt, type reset and press [Return].
The SCSI bus reset prompts appear. Answer them as indicated
below.
Figure 45
SCSI bus reset prompts
Reset Local SCSI Bus (Y, N)
Automatic reset of known SCSI Buses on RESET (Y, N) = N?
Cold/Warn Reset flag (C, W) = C?
Execute Soft Reset (Y, N)
11 When the Ò147-Diag>Ó prompt appears, type env and press
[Return].
The environment prompts appear.
12 Answer them as indicated in Figures 46, 47, or 48, depending on
the firmware installed in your system. The firmware release
appeared in the start-up messages shown in Figure 40.
Meridian Link Release 5C/CCR Release 3C Diagnostic and Maintenance Guide
Chapter 8: Recovery/replacement procedures 397
<cr>
<cr>
<cr>
?
y <cr>
N?
<cr>
<cr>
N?
<cr>
y <cr>