Nortel Meridian Meridian 1 Maintenance Manual page 415

Procedure 19: Load the operating system tape on an Application
Module with an MVME147 card (continued)
During the installation or start-up of BOS, different characters than
usual represent the character delete, line delete, and interrupt functions.
During these operations,
¥ character delete (backspace), usually [Control-h], is [#]
¥ line delete, usually [Control-u], is [@]
¥ interrupt, usually [Control-c], is Delete
If you make a mistake entering the date, use [#] to delete characters.
If you press [Delete], a Ò#Ó prompt appears; press [Control-d] to
return to where you were.
19 You are prompted to confirm the date you entered. Type y and
press [Return] if the date is correct.
If the date is not correct, type n and press [Return]. You are then
prompted to enter each value.
When you enter the date successfully and respond y to the prompt,
the BOS software management menu appears.
Figure 52
BOS software management menu
The BOS (FE03.71) Software Management Menu
1 install Install FE03.71 BOS Software
2 upgrade Upgrade To FE03.71 BOS Software
---> Enter a number, a name, the initial part of name, or
? or <number>? for HELP, q to QUIT:
Meridian Link Release 5C/CCR Release 3C Diagnostic and Maintenance Guide
Chapter 8: Recovery/replacement procedures 403
ATTENTION