Nortel Meridian Meridian 1 Maintenance Manual page 432

420 Chapter 8: Recovery/replacement procedures
553-3211-510 Standard 1.0 October 1998
Procedure 20: Load the operating system tape on an IPE Module or an
Application Module with an MVME167 card (continued)
14 Write down the vendor and description of the disk drive installed in
SCSI address 00. This information is required later in the
procedure. (In the preceeding example, the drive is a SEAGATE
ST3283N.)
15 Type the date in the form MMDDHHMMYY (month, date, hour in
24-hour clock format, minute, yearÑnote that the time should be
Eastern Standard Time), or MMDDHHMMYYYY, and press
[Return}.
Example: 0314163098 or 031416301998
During the installation or start-up of BOS, different characters than
usual represent the character delete, line delete, and interrupt functions.
During these operations,
¥ character delete (backspace), usually [Control-h], is [#]
¥ line delete, usually [Control-u], is [@]
¥ interrupt, usually [Control-c], is Delete
If you make a mistake entering the date, use [#] to delete characters.
If you press [Delete], a Ò#Ó prompt appears; press [Control-d] to
return to where you were.
16 You are prompted to confirm the date you entered. Type y and
press [Return].
If the date is not correct, type n and press [Return]. You are then
prompted to enter the date, as in step 15.
When you enter the date successfully and respond y to the prompt,
the BOS software management menu appears (Figure 82).
ATTENTION