Nortel Meridian Meridian 1 Maintenance Manual page 435

Procedure 20: Load the operating system tape on an IPE Module or an
Application Module with an MVME167 card (continued)
Note: If your drive is not listed, but another drive of the same size is
listed, use the option number for the listed drive. Although options 8,
9, 16, and 17 start with the prefix Òm147,Ó these options are also
applicable to IPE Modules and Application Modules with MVME167
cards. If you experience difficulties, contact your local Nortel support
personnel.
Disk types used
CDC ST1126N 9204 (104 Mbyte)
CDC ST1201N (172 Mbyte)
Fujitsu M2614S (180 Mbyte)
Seagate ST3283N (240 Mbyte)
20 For this example, the m147sea3283 disk drive is being used.
Type 16 and press [Return].
The system response is: ÒSelected the XXXX disk typeÓ, where
XXXX represents the disk type selected.
Figure 86
Format disk drive prompt
Selected the Ôm147sea3283Õ disk type.
If the root file systemÕs disk is new or needs to be formatted,
it can be formatted now.
dynamic disk slicing capabilities and the use of the
sledit(1M) utility you may have to reformat the disk if it
was formatted with the R3V3 or earlier version of
the BOS disk formatter, dinit(1M).
WARNING - FORMATTING THE DISK WILL DESTROY ALL DATA ON THE DISK.
---> Format the root file systemÕs disk drive (y, n, ?, q) [n]:
21 You are prompted to format the root file systemÕs disk drive. Type y
and press [Return] to indicate that you wish to format the drive.
Meridian Link Release 5C/CCR Release 3C Diagnostic and Maintenance Guide
Chapter 8: Recovery/replacement procedures 423
In order for you to take advantage of
Select this number
8
9
6
16