Nortel Meridian Meridian 1 Maintenance Manual page 234

222 Chapter 4: Diagnosing faults
553-3211-510 Standard 1.0 October 1998
Lowest LCN for DTE/DCE
circuit number that will be assigned for an incoming (if DTE) or
outgoing (if DCE) X.25 call request. It is not used by the
Application Module. The default value is -1.
Highest LCN for DTE/DCE
virtual circuit number that will be assigned for an incoming (if
DTE) or outgoing (if DCE) X.25 call request. It is not used by the
Application Module. The default value is -1.
This specifies the lowest X.25 virtual circuit number
Lowest LCN
that will be assigned for an incoming/outgoing X.25 call request.
The default value is 1.
This specifies the highest X.25 virtual circuit
Highest LCN
number that will be assigned for an incoming/outgoing X.25 call
request. The default value is 4095.
This specifies the lowest X.25 virtual circuit number
LOC LIC
that will be assigned for an incoming (if DCE) or outgoing (if
DTE) X.25 call request. It is not used by the Application Module.
The default value is -1.
This specifies the highest X.25 virtual circuit number
HOC HIC
that will be assigned for an incoming (if DCE) or outgoing (if
DTE) X.25 call request. It is not used by the Application Module.
The default value is -1.
This specifies (in 1/10 second increments) the amount of
T10
time the application will wait for an X.25 Restart Confirmation
packet after sending an X.25 Restart packet to the host (T20 for
DTE).
This specifies (in 1/10 second increments) the amount of
T11
time the host will wait for an X.25 Call Accept packet from
Meridian Link after sending an X.25 Call Request packet (T21 for
DTE).
This specifies (in 1/10 second increments) the amount of
T12
time the application will wait for an X.25 Reset Confirmation
packet after sending an X.25 Reset Request packet to the host
(T22 for DTE).
This specifies the lowest X.25 virtual
This specifies the highest X.25