Nortel Meridian Meridian 1 Maintenance Manual page 233

Remote address
This should be identical to the host computer configuration. It
T1
specifies the frame recovery time (in 1/10 second increments).
Maximum out frames (K)
computer configuration. It specifies the LAPB window size.
Maximum trans attempts (N2)
the host computer configuration. It specifies the maximum number
of retries to complete a transmission.
Local DTE address
identifies the Application Module. When the host sends the X.25
call request packet to set up the SVC, it must specify the local
DTE address of the Application Module. The default value is
000000990100.
Flow control negotiation
service which allows flow control parameters (packet size and
window size) to be negotiated between the host and the
Application Module. This is not supported by the Application
Module. The default value is "0" (no flow control negotiation).
Incoming packet size
computer configuration. It specifies the maximum X.25 packet
size.
Outgoing packet size
computer configuration. It specifies the maximum X.25 packet
size.
Incoming window size
computer configuration. It specifies the X.25 window size.
Outgoing window size
computer configuration. It specifies the X.25 window size.
Throughput negotiation used
Incoming throughput class
Outgoing throughput class
Meridian Link Release 5C/CCR Release 3C Diagnostic and Maintenance Guide
Chapter 4: Diagnosing faults 221
(See ÒInternal addressÓ).
This must be identical to the host
This value should be identical to
This is the X.25 Òcall requestÓ address that
This value must be 0. It is the X.25
This must be identical to the host
This must be identical to the host
This must be identical to the host
This must be identical to the host
This must be 0.
This must be 0.
This must be 0.