Portconfigñconfigure Terminals And Printers - Nortel Meridian Meridian 1 Maintenance Manual

60 Chapter 2: Application Module commands
portconfigÑconfigure terminals and printers
553-3211-510 Standard 1.0 October 1998
This command applies to CCR only.
The CCR application provides eight ports for printers and terminals.
However, IPE Modules can only use ports 7 and 8 for terminals and
printers. When the system is shipped, all ports are configured for printers
(off). The portconfig command enables you to display or change the
characteristics for each port. The ÒEnter PORT numberÓ prompt shows the
port numbers of available ports.
Note: Printer ports for HP printers should be configured for 9600
baud.
Example:
maint> portconfig
CCR Port Configuration Utility
1: List Port Configuration.
2: Change Port Characteristics.
Enter the number of the function you want to perform.
Displaying port characteristics
Select option 1 from the CCR Port Configuration Utility menu to display
port characteristics.
Example:
List Port Characteristics
Enter PORT number (1 - 8): 8
Characteristics of PORT #8
Port State:
BAUD Rate:
(Hit <RETURN> to go back to main menu)
(Hit the <RETURN> key to EXIT)
ÒonÓ (or Terminal)
9600