Chapter 2: Application Module Commands - Nortel Meridian Meridian 1 Maintenance Manual

Chapter 2: Application Module
commands
Meridian Link Release 5C/CCR Release 3C Diagnostic and Maintenance Guide
To use the Application Module commands in this chapter, you must be
logged in as a maintenance user (maint). The commands may be entered at
the Application Module or IPE Module console or at a terminal attached
through a modem port or a teletype (TTY) port (if available).
This chapter describes all Application Module commands that apply to
both CCR and Meridian Link. The responses that are shown in this chapter
may differ slightly from those that appear on your console (depending on
the release and level of release you are running).
Note: All input at the system console must be in lowercase (or mixed
case, if necessary) letters. User input is indicated in bold type.
You can see a list of all available commands by typing help or ? and
pressing [Return]. Table 2 lists all Application Module commands.
17