Nortel Meridian Meridian 1 Maintenance Manual page 267

Table 7
maint messages that appear on the console (continued)
Command Message
rstfiles No files selected
No files available for selection
selectool: input file not found
selectool: out of memory
selectool: unknown error
<NUMBER>: exiting
Selective restore unsuccessful
Meridian Link Release 5C/CCR Release 3C Diagnostic and Maintenance Guide
Chapter 5: Application Module and IPE Module error messages 255
Ñ continued Ñ
Description
You have pressed [Return] without
selecting a file.
No files are available to be restored.
The command which invoked the
selector is programmed incorrectly.
Report the failure to your Nortel
support personnel.
The selector cannot obtain enough
memory to function. Report the failure
to your Nortel support personnel.
A programmer error within the
selector causes an unknown error.
Report the failure to your Nortel
support personnel.
Note: <NUMBER> in the message
is replaced with the actual error
number generated.
The restore data operation was not
successful. Use the viewlog
command to search for any applic-
able errors in the SysLog file. The
problem is most likely with the tape
medium. Verify that the tape is
positioned in the drive correctly, and
that it is write enabled. Wait for the
tape drive LED to go out after
inserting the tape before executing
the command.