278 Chapter 5: Application Module and IPE Module error messages
Table 12
Application messages that appear in the SysLog file (continued)
Message
mlnkHDLC: write to trace file
failed
mlnkHDLC: above event not
processed
mlnkHDLC: msgget( ) - errno
='UNIX error number'
mlnkHDLC error in wait_msg_q( )
- errno ='UNIX error number'
mlnkHDLC: unsupported sub
type of link message
mlnkHDLC: unsupported main
type message);
Unrecoverable application Error
unsupported sub type of link
message
x25dmin: bad event:'event
number'
x25dmin: Panic # ='panic
number'
x25dmin: Sub Panic # ='sub
panic number'
553-3211-510 Standard 1.0 October 1998
Description
There is a problem writing to the trace file for link 0.
The file system may be full. Log in as maint and use
diskuse. Refer to the filedelete command if the disk
usage is greater than 95 percent. If the file system is
not full, restart the trace by logging in as mlusr and
invoking the untrace link 1 command followed by the
trace link 1 command.
This message is normally generated when the
application is started and should be ignored.
Indicates an internal application problem. Use
Procedure 2: SBC restart.
Indicates an internal application problem. Use
Procedure 2: SBC restart.
Indicates an internal application problem. Use
Procedure 2: SBC restart.
Indicates an internal application problem. Use
Procedure 2: SBC restart.
Indicates an internal application problem. Use
Procedure 2: SBC restart.
Indicates an internal application problem. Use
Procedure 2: SBC restart.
Indicates an internal application problem. Use
Procedure 2: SBC restart.
Indicates that X.25 communication software has
crashed. The application will be automatically
restarted. No action is necessary.
Indicates that X.25 communication software has
crashed. The application will be automatically
restarted. No action is necessary.
Ñ continued Ñ