Nortel Meridian Meridian 1 Maintenance Manual page 449

Procedure 21: Reboot and go through setup (continued)
9 At the ÒEnter zone number:Ó prompt, type the number corresponding
to your time zone and press [Return].
If your time zone is not listed in time zones 1Ð12, type 13 and press
[Return]. You will see explanatory messages. At the ÒEnter 3-letter
time-zone-nameÓ prompt (Figure 107), type three letters to
represent your time zone and press [Return]. At the ÒEnter time
difference from GMTÓ prompt, type the difference between your
local time and Greenwich Mean Time (GMT). Use a minus if your
time zone is west of GMT.
Figure 107
Additional time zone menu
Enter 3-letter time-zone-name (a thru z or A thru Z)
Enter time difference from GMT (use Ò-Ó if west of GMT)
Figure 108
DST prompt
Does your time zone use Daylight Savings Time during the year? [y, n, ?, q]
10 You are prompted to indicate whether your time zone uses Daylight
Savings Time during the year. Type in your response (y if Daylight
Savings Time applies, n if it does not) and press [Return].
The system response reflects whether or not the Daylight Savings
Time selection was changed.
Figure 109
Date and time change prompt
Time zone now changed.
Note: Any logins and processes running when the time zone changes, and
all their child processes, will continue to see the old time zone.
The cron will be restarted at the end of this procedure.
Current date and time:
Change the date and time? [y, n, ?, q]
Meridian Link Release 5C/CCR Release 3C Diagnostic and Maintenance Guide
Chapter 8: Recovery/replacement procedures 437
Tue. 06/29/93 09:37