Nortel Meridian Meridian 1 Maintenance Manual page 446

434 Chapter 8: Recovery/replacement procedures
553-3211-510 Standard 1.0 October 1998
Procedure 21: Reboot and go through setup (continued)
4 At the Ò#Ó prompt, type portconfig -m and press [Return].
The following messages appear on your screen.
Figure 103
Portconfig warning
THIS WILL REMOVE EXISTING tty NODES IN
CREATE NEW ONES BASED ON THE DRIVERS CONFIGURED INTO THE
MOST RECENTLY BUILT KERNEL IN
HARDWARE CONFIGURATION.
YOU WANT TO DO?
(default = n) [y, n]:
5 If there is a tape in the drive, unlock the tape drive and remove the
tape.
6 Type y and press [Return].
The port configuration messages (shown in Figure 104) appear on
your screen.
Note: Figure 104 shows an entry about adding MVME167 controller
board entries. This is present even though the SBC card is an
MVME147 card or the module is an IPE Module, and is a result of the
software supporting the IPE Module and the MVME147 and
MVME167 cards. Ignore the entry.
Ô/devÕ
Ô/usr/src/uts/m68k/cfÕ AND THE CURRENT
ARE YOU SURE THIS IS WHAT
AND