Nortel Meridian Meridian 1 Maintenance Manual page 256

244 Chapter 5: Application Module and IPE Module error messages
Table 7
maint messages that appear on the console (continued)
Command Message
applstart One or more Customer Controlled
(See ccrstart Routing processes are already
because the running
applstart
command
issues the
ccrstart
command)
CCR died due to a problem
reading the AMprofile
CCR died due to missing data in
the AMprofile
/usr/bin/add is not available
switch link process missing:
X.25admin
switch link process missing: tsmain
switch link process missing:
mlnkHDLC
553-3211-510 Standard 1.0 October 1998
Description
The application has already been
started. Any subsequent attempt to
start the application, once it has
been started, will not actually start it
again.
CCR has a problem reading the
AMprofile. The CCR software is
probably corrupted. Reinstall the
CCR software.
The data in the AMprofile has been
corrupted. Reinstall the CCR
software or consult your Nortel
support personnel.
The add process was not found. It is
likely that the application software
has not been installed successfully.
The X.25admin process was not
found. It is likely that the application
software has not been installed
successfully.
The tsmain process was not found.
It is likely that the application
software has not been installed
successfully.
The mlnkHDLC process was not
found. It is likely that the application
software has not been installed
successfully.
Ñ continued Ñ