388 Chapter 8: Recovery/replacement procedures
Procedure 17: Replace the Application Module MVME712
transition card
553-3211-510 Standard 1.0 October 1998
You must remove the Application Module from the AEM to access the
transition cards.
1
Complete Procedure 13: Remove the Application Module.
2
Loosen the screws at the top and bottom of the card faceplate (at
the rear of the Application Module).
3
Pull the card out of the Application Module.
4
Disconnect the cables to the card.
5
Check the jumpers and cable connections on the replacement card.
For DCE, check that the jumper is over the top two pins on all
jumper locations; for DTE, check that the jumper is over the bottom
two pins on all jumper locations. See Figures 36, 37, or 38.
6
Reconnect the cables to the replacement card.
7
Slide the replacement card into the back of the Application Module.
Firmly press the middle of the faceplate to seat the card.
8
Install the screws on the faceplate of the replacement card.
9
Complete Procedure 14: Replace the Application Module to
reinstall the module.