Nortel Meridian Meridian 1 Maintenance Manual page 313

The current mlusr association is #2, API_TOOL. Assuming no other
user is logged in as mlusr, association #1, ADMIN.1334, is stale. To
remove it
1. Quit the current session and enter
mlusr> quit
2. Log in as disttech. From the Òdisttech>Ó prompt execute the
following command:
/usr/mlusr/bin/rm_assoc -a Ôassociation_IDÕ
For this example:
disttech> /usr/mlusr/bin/rm_assoc -a 1
The following message sequence will take approximately 20
seconds to cycle through:
Application registration failed
Error 0x0504: Application exists
disttech>
Application Release Response not received.
Application registration successful: id = 1
disttech>
3. Log in as mlusr. Execution of the get associations command
shows the previously stale association has been restored.
The association is no longer stale and can be terminated normally
by using the quit command.
Meridian Link Release 5C/CCR Release 3C Diagnostic and Maintenance Guide
Chapter 6: Link error messages 301
Application release successful
BYE-BYE