Nortel Meridian Meridian 1 Maintenance Manual page 373

6018
Log message
MeridianÊ1. Refer to ÒNotes on flow controlÓ, CCR message 2012.
Parameters
Description
controlÓ following message 2012) was received from MeridianÊ1. This
notification indicates that previous flow control or overload conditions
that have been encountered are now cleared.
System operation is returned to normal.
Impact
None
Recovery
6019
Log message
Parameters
Description
the start-up communications sequence and is now in contact with the
software on Meridian 1; it is ready to start active call processing.
The application is ready to become operational.
Impact
None
Recovery
6020
Log message
Parameters
the error occurred.
Description
during an application shutdown. The session was ended by the CCR
system manager.
All unsaved changes were lost.
Impact
None
Recovery
Meridian Link Release 5C/CCR Release 3C Diagnostic and Maintenance Guide
Chapter 7: CCR log file messages 361
Flow control level 0 indication received from
None
A flow control level 0 indication (see ÒNotes on flow
Contact has been established with Meridian 1.
None
The call processing software has successfully completed
User session forced to log out by the software
User ID, Process ID, Lock Type, and Procedure where
The user session did not log out within the given time