Nortel Meridian Meridian 1 Maintenance Manual page 73

Changing port characteristics
Select option 2 from the CCR Port Configuration Utility menu to change
port characteristics.
Note: In the example below, <cr> indicates where you press
[Return].
Example:
Change Port Characteristics
Enter PORT number (1 - 8): 8
Available states:
Select a state (default: ÒoffÓ): on
Available BAUD Rates:
Select a BAUD rate (default: 9600): <cr>
STATE = off
BAUD = 9600
Do you want to install these new characteristics (y/n)? y
PORT #8 now has new characteristics.
Hit <RETURN> when ready to see main menu.
Note: If a printer has been defined for the port, it cannot be turned off
until the printer is deleted.
Note: If an IPE Module has port 6 configured for a terminal or
printer, this configuration will be deleted when CCR is installed
(Release 3C) or upgraded to Release 3C.
Meridian Link Release 5C/CCR Release 3C Diagnostic and Maintenance Guide
Chapter 2: Application Module commands 61
off (printer) on (terminal)
1200 2400 9600