Nortel Meridian Meridian 1 Maintenance Manual page 79

Adding a printer
You may configure a port to run a printer by turning the state to off with
the portconfig command.
You may configure the printer for the application by selecting option 1
from the printconfig menu. Ensure that the baud rate set by the portconfig
command is set to 9600 for Hewlett Packard (HP) printers.
Do not use any spaces in the printer name.
Example:
CCR ADD Printer Operation
Enter printer name: Printer1
Enter PORT number (1 - 8): 8
Select a Model number from the list provided below:
1. HP Rugged Writer.
2. HP LaserJet II, III, IV or DeskJet.
3. Other (dumb).
Enter the number of the desired printer type here: 2
Line printer scheduler stopped
destination ÒPrinter1Ó now accepting requests
printer ÒPrinter1Ó now enabled
(Hit the <RETURN> key when finished)
Deleting a printer
Select option 2 to delete a printer from the printconfig menu.
Example:
CCR Delete Printer Operation:
Enter printer name: Printer1
Removing Printer ÒPrinter1Ó...
Line printer scheduler stopped
(Hit the <RETURN> key when finished)
Meridian Link Release 5C/CCR Release 3C Diagnostic and Maintenance Guide
Chapter 2: Application Module commands 67