Installñload Software Tape Onto The Hard Disk - Nortel Meridian Meridian 1 Maintenance Manual

52 Chapter 2: Application Module commands
installÑload software tape onto the hard disk
553-3211-510 Standard 1.0 October 1998
In an initial installation, this command loads the software tape onto the
hard disk. This command instructs the program as to which applications are
to be started, and what options are to be activated in each application. The
inactive application remains on the hard disk for later activation, if the
customer buys further options and obtains a new keycode.
Example:
maint> install
You can reconfigure the system using a keycode without a tape
or you can use a tape to upgrade the software and reconfigure.
Do you want to use a tape (y/n/q/)? n
Please enter the Meridian 1 ID of this site
(or Q or q to quit): 12345
Please enter your key code (5 groups of 4 characters each):
Keycode group 1 (or Q or q to quit): a405 <cr>
Keycode group 2 (or Q or q to quit): 10e7 <cr>
Keycode group 3 (or Q or q to quit): 63de <cr>
Keycode group 4 (or Q or q to quit): be2a <cr>
Keycode group 5 (or Q or q to quit): 6ff0 <cr>
Note: If the Meridian Link application is installed, the following prompt
appears.
Please enter the Meridian Link Protocol, x for X.25, <cr> for TCP/IP): <cr>
Note: If the user chooses TCP/IP, the following prompts appear.
If you would like a default gateway IP address configured or changed,
please enter the IP address in internet dot notation (e.g. 47.82.45.10).
For no change enter <cr>: <cr>
If you would like a default subnet mask configured or changed,
please enter the subnet mask (e.g. 255.255.0.0).
For no change enter <cr>: <cr>
Ñ continued Ñ