Nortel Meridian Meridian 1 Maintenance Manual page 360

348 Chapter 7: CCR log file messages
553-3211-510 Standard 1.0 October 1998
5001
Flow control level 1 indication received from the
Log message
Meridian 1. Refer to ÒNotes on flow controlÓ, CCR message 2012.
None
Parameters
A flow control level 1 indication (see ÒNotes on flow
Description
controlÓ, following message 2012) was issued by Meridian 1,
indicating that the Meridian 1 inbound traffic flow occasionally
exceeds configured limits on Meridian 1. The system may be
temporarily operating above its capacity. A subsequent flow control
level 0 indicates when the system is again operating at normal
capacity.
Indication that message traffic exceeds what Meridian 1 is
Impact
configured to expect. It has no immediate impact, but could be
followed by a flow control 2 or 3 error.
If flow control indication does not return to 0, especially if
Recovery
the situation occurs when call volume is below normal, check
configuration parameters on Meridian 1 and change them if necessary.
If configuration is correct and the problem persists, it indicates the
system is running above capacity.
5002
Log message
session list
User ID, Process ID, Lock Type, and Procedure where
Parameters
the error occurred
This happens when the call processing software restarts,
Description
at midnight or during shutdown. If the user session does not exist, the
software deletes it from the session list.
There is no system impact.
Impact
No user intervention is needed.
Recovery
User session does not exist: deleting user from the