Nortel Meridian Meridian 1 Maintenance Manual page 475

Procedure 25: Enable or disable Ethernet LAN support (continued)
Figure 163
IP address prompt
Meridian Link using TCP/IP connection.
If you would like a default gateway IP address configured or changed, please
enter the IP address in internet dot notation (e.g. 47.82.45.10), for no change
enter <cr>:
12 To configure or change a default gateway IP address, type the IP
address in the proper format and press [Return]. If no modification
or configuration is required, simply press [Return].
Figure 164
Subnet mask prompt
Saving default gateway IP address:
If you would like a default subnet mask address configured or changed,
please enter the subnet mask address in decimal, for no change enter <cr>:
13 To configure or change a default subnet mask, type the subnet
mask address in decimal format and press [Return]. If no
modification or configuration is required, simply press [Return].
Figure 165
Verification prompt
Saving default subnet mask:
The following applications are configured:
Meridian Link
Large CCR
The following packages are configured:
1
96
97
98
99
100
101
Ethernet NSE software is enabled.
Is this correct (y/n/q)?
Meridian Link Release 5C/CCR Release 3C Diagnostic and Maintenance Guide
Chapter 8: Recovery/replacement procedures 463