442 Chapter 8: Recovery/replacement procedures
553-3211-510 Standard 1.0 October 1998
Procedure 22: Load the application software from tape (continued)
Figure 123
Software management menu
1 installpkg
install new software package onto built-in disk
2 listpkg
list packages already installed
3 removepkg
remove previously installed package from built-in disk
Enter a number, a name, the initial part of a name, or
? or <number>? for HELP,
5
At the software management menu, type 1 and press [Return] to
select the install option.
Figure 124
Drive selection menu
Select which drive to use:
1 ctape
Enter a number, a name, the initial part of a name, or
? for HELP,
q to QUIT:
6
You are prompted to select a drive. Type 1 and press [Return] to
select the ctape (cassette tape) option.
Figure 125
Insert medium prompt
Insert the removable medium for the package you want to install
into the ctape drive.
Press <RETURN> when ready.
7
You are prompted to insert the medium. Insert the application tape
(tape 2 of 2) into the tape drive and wait until the tape indicator light
turns off.
Once the tape is inserted correctly and the latch completely closed,
the tape indicator light goes on, flashes briefly, then goes off again.
Wait until the light goes off before proceeding to the next step.
SOFTWARE MANAGEMENT
q to QUIT:
2 diskette1
3 hddiskette1
Type
q
to quit.