Nortel Meridian Meridian 1 Maintenance Manual page 308

296 Chapter 6: Link error messages
553-3211-510 Standard 1.0 October 1998
090F - Link command failed due to reconfiguration of
associated link
Link 0 (AML) and link 1 (host link) use the two ports on the same
MVME705B transition card and MVME333-2 XCC card. If link 0 is
being configured, any mlusr command for link 1 will be rejected. If
link 1 is being configured, any mlusr command for link 0 will be
rejected.
To resolve this, wait for the Configuration Response message to
appear before entering another (link) command.
0910 - Trace already enabled
Trace is already enabled, and an attempt is made again to turn on the
trace. No action is necessary.
0911 - Trace already disabled
Trace is already disabled, and an attempt is made again to turn off the
trace. No action is necessary.
0912 - Link to Meridian 1 failed because required software
option not equipped
In order to use Meridian Link software, the Meridian 1 must be
equipped with package 209. Use LD22 on the Meridian 1 system
terminal to verify that package 209 is equipped.
0913 - Link to Meridian 1 failed due to Meridian 1 ID mismatch
In order to use Meridian Link software, the Meridian 1 ID must match
the ID of the Meridian Link software. Use LD22 to verify that package
209 is present. Log in as maint and use the showid command to check
the ID on the Meridian Link Module. Check the Meridian 1 ID printed
on the Meridian Link software label against the connected switch.
0914 - No link responding
No response message is received from mlink or hlink. To rectify this
problem, shut down and restart the application (including the Meridian
Link software).
The following values may appear in any of the Message Facility
(Recording, Monitoring, Statistics, Filtering) messages.