Mlusr Error Messages - Nortel Meridian Meridian 1 Maintenance Manual

This might happen when the Application Module or IPE Module is
experiencing heavy message traffic while other activities (trace running,
monitoring, and so on) are running. Avoid unnecessary activity on the
Application Module or IPE Module during high message traffic periods.

mlusr error messages

The following summary of the error messages reported by application
software to the system console covers the error messages in Application
Registration, DN Registration, Link Maintenance, and Message Facility.
Note: 0x may appear in the error message, and indicates
hexadecimal. It is not listed with the error messages in this guide.
An explanation is provided for each error message; a solution is suggested
on how to correct the error. The following message may appear in the Link
Status Response Message:
000A - Link to SL1 down pending security validation
Whenever the link to the Meridian 1 is established, checks are made to
verify that package 209 is installed and that the machine ID and the
tape ID match. This message indicates these checks are under way. If
the checks are successful, the link will establish normally.
The following values may appear in the Application Registration Response
message.
000B - Request already in progress
A user has attempted to invoke an mlusr command (such as continuity
test) that has already been invoked.
0502 - Association Table is full
Indicates the limit for the number of applications that can register has
been reached. This state can be remedied either by restarting the
application by rebooting the module or by releasing one or more
associations.
0902 - Link process does not exist
Meridian Link software MLINK or HLINK processes cannot be
invoked. To rectify this problem, shut down and restart the application
(including the Meridian Link software).
Meridian Link Release 5C/CCR Release 3C Diagnostic and Maintenance Guide
Chapter 6: Link error messages 293