Nortel Meridian Meridian 1 Maintenance Manual page 338

326 Chapter 7: CCR log file messages
553-3211-510 Standard 1.0 October 1998
2011
Log message
Cause 1, 2, 3, 4, or 5; [CDN], [Script name], and
Parameters
Miscellaneous information
1: Unable to allocate memory for a new call
2: No association for the CDN
3: No script found for the call
4: Duplicate call ID or Invalid call ID
5: Unable to execute scriptÑeither first statement encountered is
QUIT, WAIT, or SILENCE, or an invalid value for a Queue
intrinsic has been detected
An incoming call cannot be handled by CCR. The call is
Description
handed back to Meridian 1 default operation.
The call receives default treatment rather than script treatment.
Impact
Recovery differs according to cause.
Recovery
1: Call processing cannot allocate new memory for the call. If this
happens under a high load condition, it indicates the application is
running above capacity. Under low load conditions, it may
indicate a software memory allocation problem. Restart the
application.
2: A call arrived from a CDN that does not appear in the
Association Table. The CDN is switched to default mode on
Meridian 1. Add an association and reset the CDN to controlled
mode on Meridian 1.
3: The script that the association pointed to could not be found by
call processing. Software errorÑrestart the application.
4: If this message appears in the Error Log repeatedly due to
invalid call ID: 0 (hex), most likely the call ID package (247) is
not equipped in the Meridian 1 software. Make sure that the call
ID package is turned on.
Call rejected by call processing software