restartÑstop and start the link processes
This command stops all link processes and all applications running within
the application, then restarts the processes and applications, if desired. This
command, in particular, stops and restarts the link to the Meridian 1.
This command will not automatically restart applications that are external
to the Application Module or IPE Module. External applications must be
restarted manually.
To start applications but not links, use the applstart command.
To start the CCR application without starting any other applications, use
the ccrstart command.
Note: IThe following example shows the command being executed
on an Application Module or IPE Module with only the CCR
application. For modules that have only the Meridian Link application,
replace references to CCR and Customer Controlled Routing with
Meridian Link. For modules with both applications, add references to
Meridian Link.
Meridian Link Release 5C/CCR Release 3C Diagnostic and Maintenance Guide
Chapter 2: Application Module commands 71