Monitor Commands - Nortel Meridian Meridian 1 Maintenance Manual

monitor commands

The monitor commands display messages flowing on the identified
association_id on the system console. The messages appear in hexadecimal
format. There are five monitoring commands:
¥ set monitor
¥ enable monitor
¥ disable monitor
¥ clear monitor
¥ get monitor
The format of the monitor file displayed on the console is the same as for
the recording file. See Figure 10 in the record commands.
Type help msgtypes and press [Return] to see a list of all message types
that can be selected in the messages parameter. You can also type help
messages and press [Return] to see a list of message types supported by
Meridian Link software up to Release 5C.
Set monitor
Use this command to add the message types to the list of messages to be
monitored.
Command format:
mlusr> set monitor association_id message [message ... ]
Example:
To monitor makecall and answer messages for association ID 1:
mlusr> set monitor 1 0801 0809
or
mlusr> set monitor 1 mlmakecall mlanswer
Set monitor successful
mlusr>
To monitor all outgoing messages, enter:
mlusr> set monitor 2 allout
Meridian Link Release 5C/CCR Release 3C Diagnostic and Maintenance Guide
Chapter 3: Link maintenance commands 133