198
Chapter 4: Diagnosing faults
Diagnostic procedure 8
Application terminal problem (continued)
8.8
Is the PC
powered on?
YES
Does the PC boot
successfully?
YES
Does Reflection 4+
run correctly?
553-3211-510 Standard 1.0 October 1998
This procedure applies to CCR only.
NO
Connect the PC to a
power source and
turn it on.
NO
Refer to your PC
documentation to set
the PC up correctly.
NO
Refer to Reflection 4+
documentation to set
the software up
correctly. See Note.
Replace the PC.
Note: If the PC is connected
to the Application Module or IPE
Module via a modem, the
settings in Reflection 4+ must
match those of the modem.