Nortel Meridian Meridian 1 Maintenance Manual page 393

Procedure 9: Configure the Application Module MVME167 SBC card or
the IPE Module (continued)
Figure 34
Environment prompts (IPE Module)
Bug or System environment [B/S] = B?
Field Service Menu Enable [Y/N] = N?
Probe System for Supported I/O Controllers [Y/N] = Y?
Local SCSI Bus Reset on Debugger Start-up [Y/N] = Y?
Ignore CFGA Block on a Hard Disk Boot [Y/N] = Y?
Auto Boot Enable [Y/N]
Auto Boot at power-up only [Y/N] = N?
Auto Boot Controller LUN = 00?
[Return].)
Note: If you changed or reentered any values in Figure 34, you will
see two additional prompts, to which you should respond as shown in
the following figure.
Figure 35
Additional prompts (IPE Module)
Update Non-Volatile RAM (Y/N)?
Reset Local System (CPU) (Y/N)?
The system reboots automatically. Messages start to appear on the
console. If you want to reload the operating system, go to
Procedure 20: Load the operating system tape on an IPE Module or
an Application Module with an MVME167 card.
The system automatically boots into the ÒConsole Login:Ó prompt.
The next time you reboot the system, it will no longer pause at the
Ò167-Diag>Ó or Ò4120-Diag>Ó prompt.
Meridian Link Release 5C/CCR Release 3C Diagnostic and Maintenance Guide
Chapter 8: Recovery/replacement procedures 381
<cr>
<cr>
<cr>
= Y?
<cr>
Type a period (.) and press
. <cr> (
y <cr>
y <cr>
<cr>
<cr>
<cr>