Nortel Meridian Meridian 1 Maintenance Manual page 143

Enable record
This command turns on message recording. Before issuing this command,
use get record to confirm the list of messages to be recorded. If necessary,
use set record or clear record to modify the list. Recording stays active until
you disable it or exit mlusr.
Command format:
mlusr> enable record association_id
Example:
To enable recording for messages set for association_id 2:
mlusr> enable record 2
Enable record successful
mlusr>
Disable record
This command turns off message recording if it had been enabled.
Recording is also disabled when you exit mlusr. Disabling message
recording does not alter the list of messages that were set for recording.
Command format:
mlusr> disable record association_id
Example:
To disable recording for messages set for association_id 2:
mlusr> disable record 2
Disable record successful
mlusr>
Meridian Link Release 5C/CCR Release 3C Diagnostic and Maintenance Guide
Chapter 3: Link maintenance commands 131