Nortel Meridian Meridian 1 Maintenance Manual page 436

424 Chapter 8: Recovery/replacement procedures
553-3211-510 Standard 1.0 October 1998
Procedure 20: Load the operating system tape on an IPE Module or an
Application Module with an MVME167 card (continued)
Figure 87
Same disk drive prompt
The usr file system is often on the same disk drive as
the root file system, but not always.
questions determine where to install the usr file system.
---> Will the root and usr file systems be
on the same disk drive? (y, n, ?, q) [y]:
22 You are prompted to indicate whether or not the root and user file
systems will be on the same disk drive. Type y and press [Return]
to indicate yes.
Figure 88
Slice number prompt
The default usr file system slice number for the MVME167
controller is slice number 2, but it may be changed.
Enter below, the slice number where the usr file system is to be installed.
---> Enter the slice number for the usr file system (0-6, ?, q) [2]:
23 You are prompted to enter the user file system slice number. Press
[Return] to use the default slice number (2).
Phase 2 of the BOS installation begins, and the slice table appears.
Figures 89-92 show the slice tables for four different disk drives.
The following