Procedure 11: Replace The Mvme332Xt Or Mvme332Xts Acc Card - Nortel Meridian Meridian 1 Maintenance Manual

Procedure 11: Replace the MVME332XT or MVME332XTS
ACC card
1 Complete Procedure 3: Hardware powerdown.
2 Loosen the screws at the top and bottom of the card.
3 Use the ejectors to unlock the card.
4 Pull the card out of the Application Module.
5 Check the switches and jumpers on the replacement card (see
Tables 17 and 18).
6 Slide the replacement unit into the Application Module. Press hard
in the middle of the faceplate to seat the card.
7 Tighten the screws on the faceplate of the replacement card.
8 Restart power to the Application Module.
Table 17
MVME332XT ACC card switch settings
Switch
S1
S2
Table 18
MVME332XT ACC card jumper settings
Block
J1
J4
Meridian Link Release 5C/CCR Release 3C Diagnostic and Maintenance Guide
Chapter 8: Recovery/replacement procedures 383
Position
1 2 3 4
on off off off
off off on on
Jumper setting
1Ð2, 5Ð6, 7Ð9, 8Ð10, 11Ð12, 15Ð17
1Ð2
5 6 7 8
off on on on