Nortel Meridian Meridian 1 Maintenance Manual page 332

320 Chapter 7: CCR log file messages
553-3211-510 Standard 1.0 October 1998
2004
Log message
None
Parameters
The communications software has detected that the link
Description
to Meridian 1 has failed.
All call processing will immediately and automatically switch
Impact
to Meridian 1 default treatment for both existing calls and new calls.
The call processing software will lose all knowledge of any active
calls. When the link recovers, the software will recover automatically.
Investigate why the link failed and correct the problem. If
Recovery
the software doesn't seem to recover, disable and enable the link.
2005
Log message
None
Parameters
A notification is received from Meridian 1 that a
Description
Meridian 1 initialization has occurred. This notification is sent to the
CCR software after Meridian 1 has completed its initialization
procedures.
This event resynchronizes the Meridian 1 and CCR software.
Impact
Meridian 1 loses all queued calls during an initialization. CCR call
processing is stopped for all active calls when this notification is
received. If no calls were active at the time of the notification, there is
no impact to the application.
The software recovers automatically.
Recovery
Meridian 1 link failed
Meridian 1 initialized