Nortel Meridian Meridian 1 Maintenance Manual page 477

Procedure 25: Enable or disable Ethernet LAN support (continued)
Figure 167
Ethernet connection prompt
Installing NSE R3V7.1. Please wait.
Is your module connected to the Ethernet (y/n) ?
16 You are asked whether your Application Module or IPE Module is
connected to Ethernet (Figure 167).
For more information about Ethernet connections, refer to ÒMeridian
Link/CCR interface cablingÓ chapter of the Meridian Link/Customer
Controlled Routing Installation and Upgrade Guide
(NTP 553-3202-210).
If your module is not connected to Ethernet, type n and press
[Return]. Go to step 20.
If you are connected to Ethernet and you plan to use it in the near
future, type y and press [Return]. You see a message asking you to
wait. Then you see more installation messages (Figure 168). Go to
step 22.
If you are connected to Ethernet but do not plan to use it in the near
future, you may choose to type n and press [Return]. Disabling
Ethernet support increases the processing power available to your
application(s). Go to step 20.
If you disable Ethernet support, you must perform a complete
reinstallation of the base operating system and application(s) before
you can reenable Ethernet support.
Meridian Link Release 5C/CCR Release 3C Diagnostic and Maintenance Guide
Chapter 8: Recovery/replacement procedures 465
ATTENTION