Nortel Meridian Meridian 1 Maintenance Manual page 413

Procedure 19: Load the operating system tape on an Application
Module with an MVME147 card (continued)
Figure 50
Start-up interrupt menu
1) Continue System Start-up
2) Select Alternate Boot Device
3) Go To System Debugger
4) Initiate Service Call
5) Display System Test Errors
6) Dump Memory to Tape
Enter Menu #:
15 When the tape indicator goes off, type 2 and press [Return].
16 You are prompted to enter the alternate boot device. Type 4,, and
press [Return].
17 When the start-up interrupt menu reappears, type 1 and press
[Return] to continue the system start-up.
The system starts up. A series of test messages will appear on one
line across the screen for approximately 10 minutes. The system
start-up messages begin to appear as shown in the Figure 51.
Meridian Link Release 5C/CCR Release 3C Diagnostic and Maintenance Guide
Chapter 8: Recovery/replacement procedures 401