372 Chapter 8: Recovery/replacement procedures
Procedure 7: Replace the Application Module MVME147/167
SBC card
553-3211-510 Standard 1.0 October 1998
1
Complete Procedure 3: Hardware powerdown.
2
Loosen the screws at the top and bottom of the card.
3
Use the ejectors to unlock the card.
4
Pull the card out of the Application Module.
5
Slide the replacement card into the Application Module. Firmly
press the middle of the faceplate to seat the card.
6
Tighten the screws on the faceplate of the replacement card.
To configure an Application Module with an MVME147 card, follow
Procedure 8. To configure an IPE Module or an Application Module
with an MVME167 card, follow Procedure 9.
7
Restore power to the Application Module by setting the MPDU
circuit breaker to ON (up).
The system reboots into the ÒConsole Login:Ó prompt.