Nortel Meridian Meridian 1 Maintenance Manual page 476

464 Chapter 8: Recovery/replacement procedures
553-3211-510 Standard 1.0 October 1998
Procedure 25: Enable or disable Ethernet LAN support (continued)
The system lists the application or applications installed.
Note: Figure 165 only shows applications that have been selected;
they are actually enabled when the system reboots at the end of this
procedure.
14 The system prompts you to verify that the list is correct.
To check that the correct application has, or applications have,
been activated, refer to the checklist (Table 12) you completed in
Chapter 6, ÒSite survey/installation checklistÓ of the Meridian
Link/Customer Controlled Routing Installation and Upgrade Guide
(NTP 553-3202-210).
If the list is incorrect, type n and press [Return]. You are returned to
step 6. Re-key your Meridian ID and keycode. If the list of
applications is still incorrect, type q and press [Return]. The
message ÒSoftware not configuredÓ appears. Call your Nortel
support personnel for a new keycode.
If the list is correct, type y and press [Return].
If you did not purchase CCR or NSE, go to step 20.
If you did not purchase CCR but you have enabled NSE, go to step
16. For more information about Ethernet connections, refer to
ÒInstalling Ethernet LAN supportÓ in Chapter 9, ÒMeridian Link/CCR
interface cablingÓ of the Meridian Link/Customer Controlled Routing
Installation and Upgrade Guide (NTP 553-3202-210).
If you have purchased CCR, go to step 15.
Figure 166
CCR customer number prompt
Please enter the CCR customer number (0-99):
15 You are prompted to enter your CCR customer number (Figure
166). Type the number and press [Return].
Note: A two-minute pause occurs at this point before the following
messages appear.