Nortel Meridian Meridian 1 Maintenance Manual page 273

Table 10
SysLog messages that appear on the console (continued)
Message
syslog: openpipe: could not
make named pipe
syslog: openpipe: could not open
named pipe
syslog: openpipe: could not clear
NO_DELAY
syslog: midnight: cannot remove
SysLog.old
syslog: midnight: could not move
System Log - old data lost
syslog: midnight: could not
create System Log
syslog: append_syslog: write to
System Log failed
Meridian Link Release 5C/CCR Release 3C Diagnostic and Maintenance Guide
Chapter 5: Application Module and IPE Module error messages 261
Description
ErrorÑa new named pipe file could not be created.
Use Procedure 2: SBC restart.
ErrorÑthe named pipe used for error collection from
the various processes could not be opened. Use
Procedure 2: SBC restart.
WarningÑthe No Delay flag could not be cleared for
the named pipe file. The system should operate
normally and user intervention is not required.
WarningÑthe old SysLog file could not be removed.
The system should operate normally and user
intervention is not required.
WarningÑthe contents of the SysLog file could not be
copied to the old SysLog file. This may be due to the
file system being too full to support the old SysLog file.
The system should operate normally. Use the diskuse
command to check the utilization of the hard disk.
WarningÑthe SysLog file could not be created. This is
most likely due to the file system being too full to
support the SysLog file. If this condition occurs, all
messages intended for the SysLog file should be
written to the console. Use the diskuse command to
check the utilization of the hard disk.
WarningÑa failure occurred while attempting to write
to the SysLog file. The file system is probably too full
to support the SysLog file. If this condition occurs, all
messages intended for the SysLog file should be
written to the console. Use the diskuse command to
check the utilization of the hard disk.
Ñ continued Ñ