Nortel Meridian Meridian 1 Maintenance Manual page 231

5 Check the Host Link configuration parameters.
¥ Log in as mlusr and use the display link 1 command to display the
current configuration.
mlusr> display link 1
The following display appears (default values are shown):
Protocol:
Machine ID:
Delay: 0
Port type:
PDN type:
Baud rate:
RFS timer:
Remote address:
Maximum out frames (K):
Local DTE address:
Flow control negotiation:
Outgoing packet size:
Outgoing window size:
Incoming throughput class:
Lowest LCN for DTE/DCE:
Lowest LCN:
LOC LIC:
T10: 1800
T11: 2000
T13: 1800
T15: 1500
Maximum T12 retries:
mlusr> display link 2
Protocol:
Machine ID:
Delay: 0
TTY: 3
¥ The configuration parameters that need to be verified are listed
here. These parameter values must be compatible with those
defined for the host computer. Contact the host computer
administrator for assistance.
Physical DTE(0)/DCE(1)
Module or IPE Module is configured as DTE, this parameter must
be 0. If it is configured as DCE (default), this parameter must
be 1.
Meridian Link Release 5C/CCR Release 3C Diagnostic and Maintenance Guide
X25
x25dest
X
44
19200
150
3
7
000000990100
0
128
2
10
-1
1
-1
3
ASYNC
MeridianMail
If the Host Link port on the Application
Chapter 4: Diagnosing faults 219
Link type: 2
Physical DTE(0)/DCE(1):
Maximum Frame length:
Fail timer: 150
Internal address: 1
T1: 30
Maximum trans attempts (N2):
Incoming packet size:
Incoming window size:
Throughput negotiation used:
Outgoing throughput class:
DTE/DCE: -1
Highest LCN: 4095
HOC HIC: -1
T12: 1800
T14: 600
T16: 1300
Maximum T13 retries:
Link type:
1
135
7
128
2
0
10
3
3