Procedure 9: Configure The Application Module Mvme167 Sbc Card Or The Ipe Module - Nortel Meridian Meridian 1 Maintenance Manual

378 Chapter 8: Recovery/replacement procedures
Procedure 9: Configure the Application Module MVME167
SBC card or the IPE Module
553-3211-510 Standard 1.0 October 1998
MVME167 cards and IPE Modules are shipped with auto-boot no-pause
disabled, which means that at boot time, it will pause at the Ò167-Diag>Ó or
Ò4120-Diag>Ó prompt. The following configuration is necessary to enable
auto-boot no-pause.
Do not press the [Backspace] or [Delete] key when the operating
system is not installed, or you may drop out of the procedure into a
previous menu or out of the installation procedure altogether. Use #
(hold the [Shift] key and press 3) to backspace.
If you drop out of the procedure (into the Ò#Ó prompt), start the
reinstallation procedure from the beginning.
This procedure assumes that you have completed Procedures 1 and 3, and
you have just installed a new IPE Module using Procedure 16 or a new
MVME167 card in the Application Module using Procedure 7.
1 Turn on the power (if it is not already on).
If the Ò167-Diag>Ó or Ò4120-Diag>Ó prompt appears, go to step 4. If
the following messages appear on the console, go to step 2.
Figure 30
System restart messages (MVME167 card or IPE Module)
Copyright Motorola Inc. 1988 - 1992, All Rights Reserved
VME167 Debugger/Diagnostics Release Version 1.4 - 07/22/92
COLD Start
Local Memory Found = 00800000 (&8388608)
MPU Clock Speed = 25Mhz
2 Before the messages start to appear, type h. If you are too late,
press the Break key.
ATTENTION