264 Chapter 5: Application Module and IPE Module error messages
Table 11
sys_wdog messages that appear on the console
Message
sys_wdog: process 'process ID'
died
sys_wdog: dead process
'process ID' is not in watch-list
sys_wdog: dead process
<'process ID'> is not recovered --
SIGKILL
sys_wdog: dead process
<'process ID'> is not recovered --
exit(NO_RECOV)
sys_wdog: fork() failed
sys_wdog: recovering process
'process ID'
sys_wdog: execvp() failed
sys_wdog: msgget() failed
sys_wdog: bad message
received: mtype='message type'
sys_wdog: bad message
received: mtext='message text'
553-3211-510 Standard 1.0 October 1998
system watchdog
The following messages appear as a result of the system watchdog, which
acts as a process manager for application software. All messages start with
the date and time.
Description
StatusÑa dead process was detected.
StatusÑthe dead process was not matched in the
watch list.
StatusÑthe specified process died as a result of a
SIGKILL instruction.
StatusÑthe specified process died as a result of an
exit instruction.
ErrorÑan attempt to start a process failed. Use
Procedure 2: SBC restart.
StatusÑan attempt is being made to recover a
process that died.
ErrorÑan attempt to transform the calling process to a
new process failed. Use Procedure 2: SBC restart.
ErrorÑan attempt to retrieve a message queue
identifier failed. Use Procedure 2: SBC restart.
WarningÑreceived message was of the wrong type.
The system should operate normally and user
intervention is not required.
WarningÑthe text of the bad message is to follow.
The system should operate normally and user
intervention is not required.
Ñ continued Ñ